2013 Everett

2013 JAMS Technical Review Presentations
In concurrence with the CMH-17 & ASTM D30 - Everett, WA
 
TESTING & ANALYSIS
Failure of Notched Laminates Under Out-of-Plane Bending
John Parmigiani, Oregon State University
Development and Evaluation of Fracture Mechanics Test Methods For Sandwich Composites
Dan Adams, University of Utah
Damage Tolerance Test Method Development for Sandwich Composites
Dan Adams, University of Utah
Composite Thermal Damage Measurement with Hand Held FT-IR
Brian Flinn, University of Washington

ADHESIVE BONDING & REPAIR
Potential Composite Bond Contamination by Contact Angle
Ashley Tracy, University of Washington
Test Method Development for Environmental Durability of Bonded Joints
Daniel O. Adams, University of Utah
Effect of Surface Contamination on Composite Bond Integrity and Durability
Dwayne McDaniel, Florida International University
CACRC Depot Bonded Repair Investigation – Round Robin Testing
Lamia Salah, National Institute for Aviation Research, Wichita State University

Wednesday April 10, 2013

DAMAGE & ENVIRONMENT
Impact Damage Formation on Composite Aircraft Structures
Hyonny Kim, University of California, San Diego
Certification of Composite-Metal Hybrid Structures
Waruna Seneviratne, National Institute for Aviation Research, Wichita State University
Damage Growth in Fluid-Ingressed Sandwich Structures
Waruna Seneviratne, National Institute for Aviation Research, WichitaState University
Delamination/Disbond Arrest Features in Aircraft Composite Structures
Kuen Lin, University of Washington

CRASHWORTHINESS & MATERIAL ISSUES
Crashworthiness of Composites Structures
Juan Acosta, National Institute for Aviation Research, Wichita State University

Design of Energy-Absorbing CFRP Stanchions for the Cargo Floor Structure of Transport Category Airplanes
Paolo Feraboli, University of Washington, Automobil Lamborghini
Advanced Composites Structures Laboratory

Certification of Discontinuous Composite Material Forms for Aircraft Structures
Mark Tuttle, University of Washington
Development of Dynamic Mechanical Analyzer (DMA) Calibration & Testing Procedures
Matt Opliger, National Institute for Aviation Research, Wichita State University